ST7FLITE02Y1B6 View Datasheet(PDF) - STMicroelectronics
Part Name
Description
MFG CO.
ST7FLITE02Y1B6
STMicroelectronics
'ST7FLITE02Y1B6' PDF : 124 Pages View PDF
ST7LITE0xY0, ST7LITESxY0
SYSTEM INTEGRITY MANAGEMENT (Cont’d)
8.4.4 Register Description
SYSTEM INTEGRITY (SI) CONTROL/STATUS REGISTER (SICSR)
Read / Write
Reset Value: 0000 0x00 (0xh)
7
0
0
0
0
0
LOCK
ED
LVDRF AVDF AVDIE
Bit 7:4 = Reserved, must be kept cleared.
Bit 3 = LOCKED PLL Locked Flag
This bit is set by hardware. It is cleared only by a
power-on reset. It is set automatically when the
PLL reaches its operating frequency.
0: PLL not locked
1: PLL locked
If the AVDIE bit is set, an interrupt request is gen-
erated when the AVDF bit is set. Refer to Figure
21 for additional details
0: VDD over AVD threshold
1: VDD under AVD threshold
Bit 0 = AVDIE Voltage Detector interrupt enable
This bit is set and cleared by software. It enables
an interrupt to be generated when the AVDF flag is
set. The pending interrupt information is automati-
cally cleared when software enters the AVD inter-
rupt routine.
0: AVD interrupt disabled
1: AVD interrupt enabled
Application notes
Bit 2 = LVDRF LVD reset flag
This bit indicates that the last Reset was generat-
ed by the LVD block. It is set by hardware (LVD re-
set) and cleared by software (writing zero). See
WDGRF flag description in Section 11.1 for more
details. When the LVD is disabled by OPTION
BYTE, the LVDRF bit value is undefined.
The LVDRF flag is not cleared when another RE-
SET type occurs (external or watchdog), the
LVDRF flag remains set to keep trace of the origi-
nal failure.
In this case, a watchdog reset can be detected by
software while an external reset can not.
Bit 1 = AVDF Voltage Detector flag
This read-only bit is set and cleared by hardware.
Table 8. System Integrity Register Map and Reset Values
Address
(Hex.)
Register
Label
7
6
5
4
SICSR
003Ah
Reset Value
0
0
0
0
3
2
1
LOCKED LVDRF
0
x
AVDF
0
0
AVDIE
0
36/124
1
Share Link: 