ST7FLITE02Y1B6 View Datasheet(PDF) - STMicroelectronics

Part Name

Description

MFG CO.

ST7FLITE02Y1B6

8-bit microcontroller with single voltage Flash memory, data EEPROM, ADC, timers, SPI

STMicroelectronics 

Prev 41 42 43 44 45 46 47 48 49 50 Next

ST7LITE0xY0, ST7LITESxY0

POWER SAVING MODES (Cont’d)

9.4.2.1 HALT Mode Recommendations

– Make sure that an external event is available to

wake up the microcontroller from Halt mode.

– When using an external interrupt to wake up the

microcontroller, reinitialize the corresponding I/O

as “Input Pull-up with Interrupt” before executing

the HALT instruction. The main reason for this is

that the I/O may be wrongly configured due to ex-

ternal interference or by an unforeseen logical

condition.

– For the same reason, reinitialize the level sensi-

tiveness of each external interrupt as a precau-

tionary measure.

– The opcode for the HALT instruction is 0x8E. To

avoid an unexpected HALT instruction due to a

program counter failure, it is advised to clear all

occurrences of the data value 0x8E from memo-

ry. For example, avoid defining a constant in

ROM with the value 0x8E.

– As the HALT instruction clears the I bit in the CC

register to allow interrupts, the user may choose

to clear all pending interrupt bits before execut-

ing the HALT instruction. This avoids entering

other peripheral interrupt routines after executing

the external interrupt routine corresponding to

the wake-up event (reset or external interrupt).

41/124

1

Share Link: