ST7LITE25F2 View Datasheet(PDF) - STMicroelectronics
Part Name
Description
MFG CO.
ST7LITE25F2
STMicroelectronics
'ST7LITE25F2' PDF : 170 Pages View PDF
ST7LITE20F2 ST7LITE25F2 ST7LITE29F2
Power saving modes
9.6.1
interrupt). Refer to Table 12: Interrupt mapping for more details.
4. Before servicing an interrupt, the CC register is pushed on the stack. The I[1:0] bits of the CC register are
set to the current software priority level of the interrupt routine and recovered when the CC register is
popped.
5. If the PLL is enabled by option byte, it outputs the clock after an additional delay of tSTARTUP (see
Figure 12: PLL output frequency timing diagram).
Register description
AWUF control/status register (CR)
Read / Write
Reset value: 0000 0000 (0Ch)
7
0
0
0
0
0
0
AWUF
AWUM AWUEN
● Bits 7:3 = Reserved
● Bit 2 = AWUF Auto-Wakeup Flag
This bit is set by hardware when the AWU module generates an interrupt and cleared
by software on reading AWUCSR. Writing to this bit does not change its value.
0: No AWU interrupt occurred
1: AWU interrupt occurred
● Bit 1= AWUM Auto-Wakeup Measurement
This bit enables the AWU RC oscillator and connects its output to the input capture of
the 12-bit Auto-Reload timer. This allows the timer to be used to measure the AWU RC
oscillator dispersion and then compensate this dispersion by providing the right value in
the AWUPRE register.
0: Measurement disabled
1: Measurement enabled
● Bit 0 = AWUEN Auto Wake Up From Halt Enabled
This bit enables the Auto Wake Up From Halt feature:
once HALT mode is entered, the AWUF wakes up the microcontroller after a time delay
dependent on the AWU prescaler value. It is set and cleared by software.
0: AWUF (Auto Wake Up From Halt) mode disabled
1: AWUF (Auto Wake Up From Halt) mode enabled
Doc ID 8349 Rev 5
61/166
Share Link: 