Qdatasheet_Logo
Integrated circuits, Transistor, Semiconductors Search and Datasheet PDF Download Site

XE24S500C View Datasheet(PDF) - Xecom

Part Name
Description
MFG CO.
'XE24S500C' PDF : 16 Pages View PDF
Prev 11 12 13 14 15 16
XE24S Configuration Registers
S0 Answer Wireless Link Request: S0
determines if the XE24S500 automatically
responds to a wireless link request.
S0=0 No response to link requests
S0=1 Automatically respond to link request
S0=128 Enter Broadcast mode on power-
up. The register value must be stored in
nonvolatile memory with the AT&W
command.
S2 Wireless Disconnect Character - S2 sets
the ASCII character used in the disconnect
sequence. The default character is tilde “~”.
Range: 0-255
Default:126
S7 Link Set-up Timer - S7 sets the length of
time in seconds that the transceiver attempts
to create a link with the destination node.
Range: 0-60
Default: 10
S10 Link Recovery Timer - S10 determines the
how long in seconds that the transceiver tries
to recover a broken link.
Range: 0-60
Default: 10
S12 Disconnect Guard Timer - S12 sets the
guard timer before and after the disconnect
sequence in milliseconds. If any characters
are received within the window defined by
S12, the disconnect request will be ignored..
Range: 0-255
Default:20
Units: Milliseconds
S14 Bit-mapped Register - S14 stores the
values of the ATE, ATQ and ATV commands.
S23 Serial Interface Data Rate -
Range 1-10
1 = Set serial data rate to 1200 BPS
2 = Set serial data rate to 2400 BPS
3 = Set serial data rate to 4800 BPS
4 = Set serial data rate to 9600 BPS*
5 = Set serial data rate to 14400 BPS
6 = Set serial data rate to 19200 BPS
7 = Set serial data rate to 28800 BPS
8 = Set serial data rate to 38400 BPS
9 = Set serial data rate to 57600 BPS
10 = Set serial data rate to 115200 BPS
Default:4
S39 Bit-mapped Register - S39 stores the
value of the AT&K command.
S104 Group ID Number - S104 sets the Group
ID number. Multiple groups may be active in
the same area. Only units with the same
Group ID number can communicate.
Range: 0-255
Default:0
S105 Node Address - S105 sets the
transceiver’s node address. Each unit in a
network is required to have a unique node
address.
Range: 1-254
XECOM
(13)
XE24S500
Share Link: GO URL

All Rights Reserved © qdatasheet.com  [ Privacy Policy ] [ Contact Us ]