XR16C864 View Datasheet(PDF) - Exar Corporation
Part Name
Description
MFG CO.
'XR16C864' PDF : 51 Pages View PDF
XR16C864
2.97V TO 5.5V QUAD UART WITH 128-BYTE FIFO
REV. 2.2.0
EFR[6]: Auto RTS Flow Control Enable
RTS# output may be used for hardware flow control by setting EFR bit-6 to logic 1. When Auto RTS is
selected, an interrupt will be generated when the receive FIFO is filled to the programmed trigger level and
RTS de-asserts to a logic 1 at the next upper trigger level/hysteresis level. RTS# will return to a logic 0 when
FIFO data falls below the next lower trigger level/hysteresis level. The RTS# output must be asserted (logic 0)
before the auto RTS can take effect. RTS# pin will function as a general purpose output when hardware flow
control is disabled.
• Logic 0 = Automatic RTS flow control is disabled (default).
• Logic 1 = Enable Automatic RTS flow control.
EFR[7]: Auto CTS Flow Control Enable
Automatic CTS Flow Control.
• Logic 0 = Automatic CTS flow control is disabled (default).
• Logic 1 = Enable Automatic CTS flow control. Data transmission stops when CTS# input de-asserts to logic
1. Data transmission resumes when CTS# returns to a logic 0.
4.20 Software Flow Control Registers (XOFF1, XOFF2, XON1, XON2) - Read/Write
These registers are used as the programmable software flow control characters xoff1, xoff2, xon1, and xon2.
For more details, see Table 7.
4.21 FIFO Status Register (FSTAT) - Read/Write
The FIFO Status Register provides a status indication for each of the transmit and receive FIFO. These status
bits contain the inverted logic states of the TXRDY# A-D outputs and the (un-inverted) logic states of the
RXRDY# A-D outputs. The contents of the FSTAT register are placed on the data bus when the FSRS# pin (pin
76) is a logic 0. Also see FSRS# pin description.
FSTAT[3:0]: TXRDY# A-D Status Bits
Please see Table 5 for the interpretation of the TXRDY# signals.
FSTAT[7:4]: RXRDY# A-D Status Bits
Please see Table 5 for the interpretation of the RXRDY# signals.
40
Share Link: 
