C8051F327 View Datasheet(PDF) - Silicon Laboratories
Part Name
Description
MFG CO.
'C8051F327' PDF : 141 Pages View PDF
C8051F326/7
7. Reset Sources
Reset circuitry allows the controller to be easily placed in a predefined default condition. On entry to this
reset state, the following occur:
• CIP-51 halts program execution
• Special Function Registers (SFRs) are initialized to their defined reset values
• External Port pins are forced to a known state
• Interrupts and timers are disabled.
All SFRs are reset to the predefined values noted in the SFR detailed descriptions. The contents of internal
data memory are unaffected during a reset; any previously stored data is preserved. However, since the
stack pointer SFR is reset, the stack is effectively lost even though the data on the stack is not altered.
The Port I/O latches are reset to 0xFF (all logic ones) in open-drain mode. Weak pullups are enabled dur-
ing and after the reset. For VDD Monitor and Power-On Resets, the RST pin is driven low until the device
exits the reset state.
On exit from the reset state, the program counter (PC) is reset, and the system clock defaults to the inter-
nal oscillator. Refer to Section “10. Oscillators” on page 71 for information on selecting and configuring the
system clock source. Program execution begins at location 0x0000.
VDD
Supply
Monitor
+
-
Enable
Power On
Reset
'0'
(wired-OR)
/RST
XTAL2
Low
Frequency
Oscillator
Internal
Oscillator
External
Clock Input
Missing
Clock
Detector
(one-
shot)
EN
(Software Reset)
SWRSF
Reset
Funnel
Errant
FLASH
Operation
System
Clock
Clock Select
CIP-51
Microcontroller System Reset
Core
Extended Interrupt
Handler
Figure 7.1. Reset Sources
Rev. 1.1
57
Share Link: 
