EVAL-ADG936EBZ View Datasheet(PDF) - Analog Devices
Part Name
Description
MFG CO.
EVAL-ADG936EBZ
Analog Devices
'EVAL-ADG936EBZ' PDF : 16 Pages View PDF
ADG936/ADG936-R
Data Sheet
TERMINOLOGY
Table 5.
Parameter
Description
VDD
IDD
GND
INx
VINL
VINH
IINL (IINH)
CIN
tON
tOFF
tRISE
tFALL
Off Isolation
Insertion Loss
Most Positive Power Supply Potential.
Positive Supply Current.
Ground (0 V) Reference.
Logic Control Input.
Maximum Input Voltage for Logic 0.
Minimum Input Voltage for Logic 1.
Input Current of the Digital Input.
Digital Input Capacitance.
Delay Between Applying the Digital Control Input and the Output Switching On.
Delay Between Applying the Digital Control Input and the Output Switching Off.
Rise Time. Time for the RF signal to rise from 10% of the on level to 90% of the on level.
Fall Time. Time for the RF signal to fall from 90% of the on level to 10% of the on level.
The Attenuation Between Input and Output Ports of the Switch When the Switch Control Voltage Is in the Off
Condition.
The Attenuation Between Input and Output Ports of the Switch When the Switch Control Voltage Is in the On
Condition.
Crosstalk
Measure of Unwanted Signal Coupled Through from One Channel to Another as a Result of Parasitic Capacitance.
P–1 dB
1 dB Compression Point. The RF input power level at which the switch insertion loss increases by 1 dB over its low level
value. P–1 dB is a measure of how much power the on switch can handle before the insertion loss increases by 1 dB.
IP3
Third-Order Intermodulation Intercept. This is a measure of the power in false tones that occurs when closely spaced
tones are passed through a switch, whereby the nonlinearity of the switch causes these false tones to be generated.
Return Loss
The Amount of Reflected Power Relative to the Incident Power at a Port. Large return loss indicates good matching. By
measuring return loss, the voltage standing wave ratio (VSWR) can be calculated from conversion charts. VSWR
indicates the degree of matching present at a switch RF port.
Video Feedthrough Spurious Signals Present at the RF Ports of the Switch When the Control Voltage Is Switched from High to Low or from
Low to High Without an RF Signal Present.
Rev. B | Page 6 of 16
Share Link: 