L6919E View Datasheet(PDF) - STMicroelectronics
Part Name
Description
MFG CO.
'L6919E' PDF : 33 Pages View PDF
L6919E
Two main configurations can be distinguished: Single Supply (VCC=VIN=12V) and Double Supply (VCC=12V
VIN=5V or different).
– Single Supply: In this case JP6 has to be completely shorted. The device is supplied with the same rail
that is used for the conversion. With an additional zener diode DZ1 a lower voltage can be derived to
supply the mosfets driver if Logic level mosfet are used. In this case JP1 must be left open so that the
HS driver is supplied with VIN-VDZ1 through BOOTx and JP2 must be shorted to the left to use VIN or to
the right to use VIN-VDZ1 to supply the LS driver through VCCDR pin. Otherwise, JP1 must be shorted
and JP2 can be freely shorted in one of the two positions.
– Double Supply: In this case VCC supply directly the controller (12V) while VIN supplies the HS drains
for the power conversion. This last one can start indifferently from the 5V bus (Typ.) or from other buses
allowing maximum flexibility in the power conversion. Supply for the mosfet driver can be programmed
through the jumpers JP1, JP2 and JP6 as previously illustrated. JP6 selects now VCC or VIN depending
on the requirements.
Some examples are reported in the following Figures 21 and 22.
Figure 21. Jumpers configuration: Double Supply
Vin = 5V
GNDin
JP6
Vcc = 12V
DZ1
JP2
JP1
Vcc = 12V
HS Drains = 5V
HS Supply = 5V
VCCDR (LS Supply) = 5V
GNDcc
Vin = 5V
GNDin
Vcc = 12V
GNDcc
(a) VCC = 12V; VBOOTx = VCCDR = VIN = 5V
Vcc = 12V
HS Drains = 5V
HS Supply = 12V
JP6
DZ1
JP2
JP1
VCCDR (LS Supply) = 12V
(b) VCC = VBOOTx = VCCDR = 12V; VIN = 5V
Figure 22. Jumpers configuration: Single Supply
Vin = 12V
GNDin
JP6
Vcc = Open
DZ1 6.8V
JP2
JP1
Vcc = 12V
HS Drains = 12V
HS Supply = 5.2V
VCCDR (LS Supply) = 12V
GNDcc
Vin = 12V
GNDin
Vcc = Open
(a) VCC = VIN = VCCDR = 12V; VBOOTx = 5.2V
Vcc = 12V
HS Drains = 12V
HS Supply = 12V
JP6
DZ1
JP2
JP1
VCCDR (LS Supply) = 12V
GNDcc
(b) VCC = VIN = VBOOTx = VCCDR = 12V
25/33
Share Link: 
