Qdatasheet_Logo
Integrated circuits, Transistor, Semiconductors Search and Datasheet PDF Download Site

PCF85263ATL/A View Datasheet(PDF) - NXP Semiconductors.

Part Name
Description
MFG CO.
'PCF85263ATL/A' PDF : 100 Pages View PDF
NXP Semiconductors
PCF85263A
Tiny RTC with alarm, battery switch-over, and I2C-bus
The assertion of flags A1F or A2F can be used to generate an interrupt at the pins INTA
and INTB. The interrupt may be generated as a pulse signal every time the time
increments to match the alarm setting or as a permanently active signal which follows the
condition of bit A1F and/or A2F. See Section 8.9 on page 38 for interrupt control.
A1F and A2F remain set until cleared by command. Once an alarm flag has been cleared,
it will only be set again when the time increments to match the alarm condition once more.
When an interrupt pin is configured to pulse mode and if an alarm flag is not cleared and
the time increments to match the alarm condition again, then a repeated interrupt pulse
will be generated.
8.5 WatchDog
Table 17. WatchDog - WatchDog control and register (address 2Dh) bit description
Bit
Symbol
Value
Description
7
WDM
WatchDog mode
0[1]
single shot
1
repeat mode
6 to 2 WDR[4:0]
WatchDog register bits
0h[1] to 1Fh
Write: WatchDog counter load value
0h to 1Fh
Read: current counter value
1 to 0 WDS[1:0]
WatchDog step size (source clock)
00[1]
4 seconds (0.25 Hz)
01
1 second (1 Hz)
10
14 second (4 Hz)
11
116 second (16 Hz)
[1] Default value.
8.5.1 WatchDog functions
The WatchDog has four selectable step sizes allowing for periods in the range from
62.5 ms to 124 seconds. For periods greater than 2 minutes, the alarm function can be
used.
WatchDog-duration = WDR stepsize
(1)
Table 18. WatchDog durations
WDS[1:0] WatchDog step Delay
size[1]
Minimum WatchDog duration
WDR = 1
00
4s
4s
01
1s
1s
10
14 s
11
116 s
0.25 s
0.0625 s
[1] Time periods can be affected by correction pulses.
Maximum WatchDog duration
WDR = 31
124 s
31 s
7.75 s
1.9375 s
PCF85263A
Product data sheet
All information provided in this document is subject to legal disclaimers.
Rev. 4.1 — 27 November 2015
© NXP Semiconductors N.V. 2015. All rights reserved.
26 of 100
Share Link: GO URL

All Rights Reserved © qdatasheet.com  [ Privacy Policy ] [ Contact Us ]