PCF8536AT/1 View Datasheet(PDF) - NXP Semiconductors.

Part Name

Description

MFG CO.

PCF8536AT/1

Universal LCD driver for low multiplex rates including a 6 channel PWM generator

NXP Semiconductors. 

Prev 21 22 23 24 25 26 27 28 29 30 Next

NXP Semiconductors

PCF8536

Universal LCD low multiplex driver with 6 channel PWM generator

8.1.15 Command: write-PWM-data

This command will initiate the transfer of data to the PWM registers. Data will be written

into the address defined by the load-data-pointer-PWM command. PWM register filling is

described in Section 8.10

Table 28. Write-PWM-data - write PWM data command bit description[1]

Bit

Symbol

Value

Description

7

-

0

fixed value

6 to 0 P[6:0]

0000000[2] to writing data byte-wise to PWM registers

1111111

[1] For this command to be effective bit RS[1:0] of the control byte has to be set logic 10, see Table 36 on

page 46.

[2] Default value. After Power-On Reset (POR) the PWM content is set to 0.

8.2 Start-up and shut-down

8.2.1 Reset and Power-On Reset (POR)

After a reset and at power-on the PCF8536 resets to starting conditions as follows:

1. The display is disabled.

2. All backplane outputs are set to VSS.

3. All segment outputs are set to VSS.

4. All GPO outputs are disabled.

5. Selected drive mode is: 1:8 with 1⁄4 bias.

6. The data pointers are cleared (set logic 0).

7. PWM values are all reset to zero.

8. RAM data is not initialized. Its content can be considered to be random.

9. The internal oscillator is running; no clock signal is available on pin OSCCLK; pin

OSCCLK is in 3-state.

The reset state is as shown in Table 29.

PCF8536

Product data sheet

All information provided in this document is subject to legal disclaimers.

Rev. 1 — 6 October 2011

© NXP B.V. 2011. All rights reserved.

21 of 74

Share Link: