Qdatasheet_Logo
Integrated circuits, Transistor, Semiconductors Search and Datasheet PDF Download Site

PIC10LF320 View Datasheet(PDF) - Microchip Technology

Part Name
Description
MFG CO.
PIC10LF320
Microchip
Microchip Technology Microchip
'PIC10LF320' PDF : 210 Pages View PDF
PIC10(L)F320/322
12.0 FIXED VOLTAGE REFERENCE
(FVR)
The Fixed Voltage Reference, or FVR, is a stable
voltage reference, independent of VDD, with 1.024V,
2.048V or 4.096V selectable output levels. The output
of the FVR can be configured to supply a reference
voltage to the following:
• ADC input channel
The FVR can be enabled by setting the FVREN bit of
the FVRCON register.
12.1 Independent Gain Amplifiers
The output of the FVR supplied to the ADC is routed
through an independent programmable gain amplifier.
The amplifier can be configured to amplify the
reference voltage by 1x, 2x or 4x, to produce the three
possible voltage levels.
The ADFVR<1:0> bits of the FVRCON register are
used to enable and configure the gain amplifier settings
for the reference supplied to the ADC module. Refer-
ence Section 15.0 “Analog-to-Digital Converter
(ADC) Module” for additional information.
To minimize current consumption when the FVR is
disabled, the FVR buffers should be turned off by
clearing the ADFVR<1:0> bits.
FIGURE 12-1:
12.2 FVR Stabilization Period
When the Fixed Voltage Reference module is enabled, it
requires time for the reference and amplifier circuits to
stabilize. Once the circuits stabilize and are ready for use,
the FVRRDY bit of the FVRCON register will be set. See
Section 24.0 “Electrical Specifications” for the
minimum delay requirement.
VOLTAGE REFERENCE BLOCK DIAGRAM
ADFVR<1:0>
2
x1
x2
x4
FVR
(To ADC Module)
FVREN
Any peripheral requiring
the Fixed Reference
(See Table 12-1)
1.024V Fixed
Reference
+
FVRRDY
-
TABLE 12-1: PERIPHERALS REQUIRING THE FIXED VOLTAGE REFERENCE (FVR)
Peripheral
Conditions
Description
HFINTOSC
BOR
IVR
FOSC = 1
BOREN<1:0> = 11
BOREN<1:0> = 10 and BORFS = 1
BOREN<1:0> = 01 and BORFS = 1
All PIC10F320/322 devices, when
VREGPM1 = 1 and not in Sleep
EC on CLKIN pin.
BOR always enabled.
BOR disabled in Sleep mode, BOR Fast Start enabled.
BOR under software control, BOR Fast Start enabled.
The device runs off of the Power-Save mode regulator when
in Sleep mode.
2011-2015 Microchip Technology Inc.
DS40001585D-page 77
Share Link: GO URL

All Rights Reserved © qdatasheet.com  [ Privacy Policy ] [ Contact Us ]