PIC16C505-04 View Datasheet(PDF) - Microchip Technology
Part Name
Description
MFG CO.
'PIC16C505-04' PDF : 85 Pages View PDF
PIC16C505
DC CHARACTERISTICS
Param
No.
Characteristic
Standard Operating Conditions (unless otherwise specified)
Operating temperature 0°C ≤ TA ≤ +70°C (commercial)
–40°C ≤ TA ≤ +85°C (industrial)
–40°C ≤ TA ≤ +125°C (extended)
Operating voltage VDD range as described in DC spec Section 10.1 and
Section 10.3.
Sym Min Typ† Max Units
Conditions
Output High Voltage
D090 I/O ports/CLKOUT (Note 3)
D090A
D092 OSC2
D092A
D100
Capacitive Loading Specs on
Output Pins
OSC2 pin
D101 All I/O pins and OSC2
VOH VDD - 0.7 —
—
VDD - 0.7 —
—
VDD - 0.7 —
—
VDD - 0.7 —
—
V IOH = -3.0 mA, VDD = 4.5V,
–40°C to +85°C
V IOH = -2.5 mA, VDD = 4.5V,
–40°C to +125°C
V IOH = -1.3 mA, VDD = 4.5V,
–40°C to +85°C
V IOH = -1.0 mA, VDD = 4.5V,
–40°C to +125°C
COSC2
—
CIO
—
— 15 pF In XT, HS and LP modes when
external clock is used to drive
OSC1.
— 50 pF
† Data in “Typ” column is at 5V, 25°C unless otherwise stated. These parameters are for design guidance only and are not
tested.
Note 1: In EXTRC oscillator configuration, the OSC1/CLKIN pin is a Schmitt Trigger input. It is not recommended that the PIC16C505
be driven with external clock in RC mode.
2: The leakage current on the MCLR pin is strongly dependent on the applied voltage level. The specified levels represent nor-
mal operating conditions. Higher leakage current may be measured at different input voltages.
3: Negative current is defined as coming out of the pin.
4: Does not include GP3. For GP3 see parameters D061 and D061A.
5: This spec. applies to GP3/MCLR configured as external MCLR and GP3/MCLR configured as input with internal pull-up
enabled.
6: This spec. applies when GP3/MCLR is configured as an input with pull-up disabled. The leakage current of the MCLR circuit
is higher than the standard I/O logic.
© 1999 Microchip Technology Inc.
DS40192C-page 63
Share Link: 
