STA306 View Datasheet(PDF) - STMicroelectronics
Part Name
Description
MFG CO.
'STA306' PDF : 33 Pages View PDF
STA306
3.1.3 Serial Audio Input Interface First Bit
BIT R/W RST NAME
DESCRIPTION
5 R/W
0
SAIFB Determines MSB or LSB first for all SAI formats
0 – MSB First, 1 – LSB First
3.1.4 Zero-Crossing Volume Enable
BIT
R/W
RST
NAME
DESCRIPTION
6
R/W
1
ZCE
Zero-Crossing Volume Enable :
1 – Volume adjustments will only occur at digital zero-crossings
0 – Volume adjustments will occur immediately
The ZCE bit enables zero-crossing volume adjustments. When volume is adjusted on digital zero-crossings,
"zipper noise" is eliminated
3.1.5 Dynamic Range Compression/Anti-Clipping Bit
BIT
R/W
RST NAME
DESCRIPTION
7
R/W
0
DRC Dynamic Range Compression/Anti-Clipping
0 – Limiters act in Anti-Clipping Mode
1- Limiters act in Dynamic Range Compression Mode
Both limiters can be used in one of two ways, anti-clipping or dynamic range compression. When used in anti-
clipping mode the limiter threshold values are constant and dependent on the gain/attenuation settings applied
to the input signal. In dynamic range compression mode the limiter threshold values vary with the volume set-
tings allowing for limiting to occur independently of the gain/attenuation but dependent on the input signal
3.2 Configuration Register C (address 02h)
BIT
D7
D6
D5
D4
D3
D2
D1
D0
NAME
HPB
RES
RES
RES
RES
RES
OM1
OM0
RST
0
1
1
1
1
1
0
0
3.2.1 DDX Power Output Mode
BIT R/W RST NAME
DESCRIPTION
0
R/W
0
OM0 DDX Power Output Mode : Selects configuration of DDX output.
1
R/W
0
OM1
The DDX Power Output Mode selects how the DDX output timing is configured. Different power devices use
different output modes. The DDX recommended use is OM = 00. The variable mode uses the OMVx bits for
adjustment
OM(1,0)
Output Stage - Mode
00
Fixed Compensation
01
RESERVED
10
Full Power Mode recommended for STA500 and STA505
11
RESERVED
14/33
Share Link: 
