TGS2351
DC – 6 GHz High Power SPDT Switch
Application Circuit
Vc2 2, 7
J1
1
RF In
Vc1 3, 6
4
J2
RF Out1
5
J3
RF Out2
Vc1 can be biased from either bond pad 3 or 6, and the non-biased bond pad can be left open.
Vc2 can be biased from either bond pad 2 or 7, and the non-biased bond pad can be left open.
This switch can be configured as a Single Pole, Single Throw (SPST) by terminating one unused
RF Out port with a 50 Ohm load.
Bias-up Procedure
Vc1 or Vc2 set to -40 V (see Function Table below for RF Path)
Vc2 or Vc1 set to 0 V (see Function Table below for RF Path)
Apply RF signal to RF Input
Bias-down Procedure
Turn off RF supply
Turn Vc1 to 0V
Turn Vc2 to 0 V
Function Table
RF Path
RF In to RF Out1 (50 Ohm load to RF Out2)
RF In to RF Out2 (50 Ohm load to RF Out1)
State
On-State (Insertion Loss)
Off-State (Isolation)
On-State (Insertion Loss)
Off-State (Isolation)
Vc1
0V
-40 V
-40 V
0V
Vc2
-40 V
0V
0V
-40 V
Data Sheet: Rev B 06/20/12
© 2012 TriQuint Semiconductor, Inc.
- 6 of 11 -
Disclaimer: Subject to change without notice
Connecting the Digital World to the Global Network®