Qdatasheet_Logo
Integrated circuits, Transistor, Semiconductors Search and Datasheet PDF Download Site

ATEMGA128L View Datasheet(PDF) - Atmel Corporation

Part Name
Description
MFG CO.
'ATEMGA128L' PDF : 395 Pages View PDF
ATmega128
Moving Interrupts Between
Application and Boot Space
MCU Control Register –
MCUCR
$F049
$F04A
$F04B
out SPL,r16
sei
<instr> xxx
; Enable interrupts
The General Interrupt Control Register controls the placement of the interrupt vector
table.
Bit
Read/Write
Initial Value
7
6
5
SRE SRW10
SE
R/W
R/W
R/W
0
0
0
4
SM1
R/W
0
3
SM0
R/W
0
2
SM2
R/W
0
1
IVSEL
R/W
0
0
IVCE
R/W
0
MCUCR
• Bit 1 – IVSEL: Interrupt Vector Select
When the IVSEL bit is cleared (zero), the interrupt vectors are placed at the start of the
Flash memory. When this bit is set (one), the interrupt vectors are moved to the begin-
ning of the Boot Loader section of the flash. The actual address of the start of the Boot
Flash section is determined by the BOOTSZ fuses. Refer to the section “Boot Loader
Support – Read-While-Write Self-Programming” on page 276 for details. To avoid unin-
tentional changes of interrupt vector tables, a special write procedure must be followed
to change the IVSEL bit:
1. Write the Interrupt Vector Change Enable (IVCE) bit to one.
2. Within four cycles, write the desired value to IVSEL while writing a zero to IVCE.
Interrupts will automatically be disabled while this sequence is executed. Interrupts are
disabled in the cycle IVCE is set, and they remain disabled until after the instruction
following the write to IVSEL. If IVSEL is not written, interrupts remain disabled for four
cycles. The I-bit in the Status Register is unaffected by the automatic disabling.
Note:
If interrupt vectors are placed in the Boot Loader section and Boot Lock bit BLB02 is pro-
grammed, interrupts are disabled while executing from the Application section. If interrupt
vectors are placed in the Application section and Boot Lock bit BLB12 is programed,
interrupts are disabled while executing from the Boot Loader section. Refer to the section
“Boot Loader Support – Read-While-Write Self-Programming” on page 276 for details on
Boot Lock bits.
63
2467O–AVR–10/06
Share Link: GO URL

All Rights Reserved © qdatasheet.com  [ Privacy Policy ] [ Contact Us ]