Philips Semiconductors
LPC2131/2132/2134/2136/2138
Single-chip 16/32-bit microcontrollers
7. Limiting values
Table 9: Limiting values
In accordance with the Absolute Maximum Rating System (IEC 60134). [1]
Symbol Parameter
Conditions
VDD
VDDA
VBAT
VREF
VIA
VI
VI
supply voltage, core and external rail
analog 3.3 V pad supply voltage
RTC power supply voltage
A/D converter reference voltage
analog input voltage on A/D related pins
DC input voltage, 5 V tolerant I/O pins
DC input voltage, other I/O pins
IDD
ISS
Tstg
Ptot(pack)
DC supply current per supply pin
DC ground current per ground pin
storage temperature [6]
total power dissipation
based on package
heat transfer, not
device power
consumption
Min
−0.5
−0.5
−0.5
−0.5
−0.5
[2] [3] −0.5
[2] −0.5
-
-
−40
-
Max
+3.6
4.6
4.6
4.6
5.1
6.0
VDD +
0.5 [4]
100 [5]
100 [5]
125
1.5
Unit
V
V
V
V
V
V
V
mA
mA
°C
W
[1] The following applies to the Limiting values:
a) Stresses above those listed under Limiting values may cause permanent damage to the device. This is a stress rating only and
functional operation of the device at these or any conditions other than those described in Section 8 “Static characteristics”and
Section 9 “Dynamic characteristics” of this specification is not implied.
b) This product includes circuitry specifically designed for the protection of its internal devices from the damaging effects of excessive
static charge. Nonetheless, it is suggested that conventional precautions be taken to avoid applying greater than the rated maximum.
c) Parameters are valid over operating temperature range unless otherwise specified. All voltages are with respect to VSS unless
otherwise noted.
[2] Including voltage on outputs in 3-state mode.
[3] Only valid when the VDD supply voltage is present.
[4] Not to exceed 4.6 V.
[5] The peak current is limited to 25 times the corresponding maximum current.
[6] Dependent on package type.
9397 750 14868
Preliminary data sheet
Rev. 02 — 15 April 2005
© Koninklijke Philips Electronics N.V. 2005. All rights reserved.
29 of 41