LTC6945 View Datasheet(PDF) - Linear Technology
Part Name
Description
MFG CO.
'LTC6945' PDF : 28 Pages View PDF
LTC6945
OPERATION
The CPWIDE bit extends the charge pump output current
pulse width by increasing the PFD reset path’s delay value
(see Figure 3). CPWIDE is normally set to 0.
VCO INPUT BUFFER
The VCO frequency is applied differentially on pins VCO+ and
VCO–. The inputs are self-biased and must be AC-coupled.
Alternatively, the inputs may be used single-ended by ap-
plying the VCO frequency at VCO+ and bypassing VCO– to
GND with a capacitor. Each input provides a single-ended
121Ω resistance to aid in impedance matching at high
frequencies. See the Applications Information section for
matching guidelines.
VVCO+
+– 0.9V
VVCO+
VVCO+
VCO+
16
121Ω
121Ω
VC0–
15
6945 F06
Figure 6. Simplified VCO Interface Schematic
VCO (N) DIVIDER
The 16-bit N divider provides the feedback from the VCO
input buffer to the PFD. Its divide ratio N may be set to any
integer from 32 to 65535, inclusive. Use the ND[15:0] bits
found in registers h05 and h06 to directly program the N
divide ratio. See the Applications Information section for
the relationship between N and the fREF, fPFD, fVCO and
fRF frequencies.
OUTPUT (O) DIVIDER
The 3-bit O divider can reduce the frequency from the VCO
input buffer to the RF output buffer to extend the output
frequency range. Its divide ratio O may be set to any in-
teger from 1 to 6, inclusive, outputting a 50% duty cycle
even with odd divide values. Use the OD[2:0] bits found
in register h08 to directly program the 0 divide ratio. See
the Applications Information section for the relationship
between O and the fREF, fPFD, fVCO and fRF frequencies.
RF OUTPUT BUFFER
The low noise, differential output buffer produces a dif-
ferential output power of –6dBm to 3dBm, settable with
bits RFO[1:0] according to Table 7. The outputs may be
combined externally, or used individually. Terminate any
unused output with a 50Ω resistor to VRF+.
Table 7. RFO[1:0] Programming
RFO[1:0}
0
PRF (Differential)
–6dBm
1
–3dBm
2
0dBm
3
3dBm
PRF (Single-Ended)
–9dBm
–6dBm
–3dBm
0dBm
Each output is open collector with 136Ω pull-up resistors
to VRF+, easing impedance matching at high frequencies.
See Figure 7 for circuit details and the Applications Infor-
mation section for matching guidelines. The buffer may be
muted with either the OMUTE bit, found in register h02,
or by forcing the MUTE input low.
VRF+
VRF+
136Ω
136Ω
RF+
12
RF– 11
MUTE
9
OMUTE
MUTE
RFO[1:0]
6945 F07
Figure 7. Simplified RF Interface Schematic
6945f
13
Share Link: 
