M25PE40-VMN6G View Datasheet(PDF) - Numonyx -> Micron
Part Name
Description
MFG CO.
M25PE40-VMN6G
Numonyx -> Micron
'M25PE40-VMN6G' PDF : 62 Pages View PDF
DC and AC parameters
M25PE40
Table 21.
AC characteristics (50 MHz operation, T9HX (0.11µm) process(1))(2)
Test conditions specified in Table 14 and Table 15
Symbol Alt.
Parameter
Min.
Typ.
Max. Unit
Clock frequency for the following instructions:
fC
fC FAST_READ, RDLR, PW, PP, WRLR, PE, SE, D.C.
SSE, DP, RDP, WREN, WRDI, RDSR, WRSR
50 MHz
fR
Clock frequency for READ instructions
D.C.
tCH(3) tCLH Clock High time
9
tCL(3) tCLL Clock Low time
9
Clock Slew Rate (peak to peak)
0.1
33 MHz
ns
ns
V/ns
tSLCH tCSS S Active Setup time (relative to C)
5
ns
tCHSL
S Not Active Hold time (relative to C)
5
ns
tDVCH tDSU Data In Setup time
2
ns
tCHDX tDH Data In Hold time
5
ns
tCHSH
S Active Hold time (relative to C)
5
ns
tSHCH
S Not Active Setup time (relative to C)
5
ns
tSHSL tCSH S Deselect time
tSHQZ(4) tDIS Output Disable time
100
ns
8
ns
tCLQV tV Clock Low to Output Valid under 30 pF/10 pF
8/6 ns
tCLQX tHO Output Hold time
0
tWHSL(5)
Write Protect Setup time
50
tSHWL(5)
Write Protect Hold time
100
tDP(4)
S to Deep Power-down
tRDP(4)
S High to Standby mode
ns
ns
ns
3
µs
30
µs
tW
tPW(6)
Write Status Register cycle time
Page Write cycle time (256 bytes)
3
15 ms
11
23 ms
tPP(6)
Page Program cycle time (256 bytes)
Page Program cycle time (n bytes)
0.8
int(n/8) × 0.025(7)
3
ms
tPE
Page Erase cycle time
tSE
Sector Erase cycle time
tSSE
Subsector Erase cycle time
tBE
Bulk Erase cycle time
10
20 ms
1.5
5
s
80
150 ms
8
10
s
1. See Important note on page 6.
2. Details of how to find the technology process in the marking are given in AN1995, see also Section 13: Ordering
information.
3. tCH + tCL must be greater than or equal to 1/ fC.
4. Value guaranteed by characterization, not 100% tested in production.
5. Only applicable as a constraint for a WRSR instruction when SRWD is set to ‘1’.
6. When using PP and PW instructions to update consecutive bytes, optimized timings are obtained with one sequence
including all the bytes versus several sequences of only a few bytes (1 ≤ n ≤ 256).
7. int(A) corresponds to the upper integer part of A. For instance, int(12/8) = 2, int(32/8) = 4 int(15.3) =16.
50/62
Share Link: 