ST7689-G4 View Datasheet(PDF) - Sitronix Technology Co., Ltd.
Part Name
Description
MFG CO.
ST7689-G4
Sitronix Technology Co., Ltd.
'ST7689-G4' PDF : 195 Pages View PDF
ST7689
Before writing to the RAM, a window must be defined into which will be written. The window is programmable via the
command registers XS, YS designating the start address and XE, YE designating the end address.
For example the whole display contents will be written, the window is defined by the following values: XS=0 (0h) YS=0
(0h) and XE=127 (7Fh), YE=159 (9Fh).
In vertical addressing mode (MV=1), the Y-address increments after each byte, after the last Y-address (Y=YE), Y
wraps around to YS and X increments to address the next column. In horizontal addressing mode (MV=0), the X-address
increments after each byte, after the last X-address (X=XE), X wraps around to SC and Y increments to address the next
row. After the every last address (X=XE and Y=YE) the address pointers wrap around to address (X=XS and Y=YS). For
flexibility in handling a wide variety of display architectures, the commands “CASET, RASET” and “MADCTL”, define flags
MX, MY and MV, which allows mirroring of the X-address and Y-address. All combinations of flags are allowed. Figure 5
show the available combinations of writing to the display RAM. When MX, MY and MV will be changed the data must be
rewritten to the display RAM.
For each image condition, the controls for the column and row counters apply as below:
Condition
When RAMWR command is accepted
Complete Pixel Read / Write action
Column Counter
Return to “Start
Column (XS)”
Increment by 1
Row Counter
Return to “Start
Row (YS)”
No change
The Column counter value is larger than “End Column (XE)”
The Row counter value is larger than “End Row (YE)”
Return to “Start
Column (XS)”
Return to “Start
Column (XS)”
Increment by 1
Return to “Start
Row (YS)”
Version 1.0
Page 39 of 195
2009/10
Share Link: 