áç
XRT7302
FEBRUARY 2000
2 CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT
REV. 1.1.0
GENERAL DESCRIPTION
The XRT7302 Dual Channel E3/DS3/STS-1 Trans-
ceiver IC consists of two fully integrated transmitter
and receiver line transceivers designed for E3, DS3
or SONET STS-1 applications.
Each channel within the XRT7302 device can be con-
figured to support the E3 (34.368 Mbps), DS3
(44.736 Mbps) or the SONET STS-1 (51.84 Mbps)
rates. Each channel can be configured to operate in a
mode/data rate that is independent of the other chan-
nel.
In the transmit direction, each channel within the
XRT7302 will encode input data to either B3ZS or
HDB3 format and convert the data into the appropri-
ate pulse shapes for transmission over coaxial cable
via a 1:1 transformer.
In the receive direction, the XRT7302 can perform
Equalization on incoming signals, perform Clock Re-
covery, decode data from either B3ZS or HDB3 for-
mat, convert the receive data into TTL/CMOS format,
check for LOS or LOL conditions and detect and de-
clare the occurrence of Line code Violations.
APPLICATIONS
• Digital Cross Connect Systems
• CSU/DSU Equipment
• Routers
• Fiber Optic Terminals
• Multiplexers
• ATM Switches
FEATURES
• Meets E3/DS3/STS-1 Jitter Tolerance Require-
ments
• Contains a 4-Wire Microprocessor Serial Interface
• Full Loop-back Capability
• Transmit and Receive Power Down Modes
• Full Redundancy Support
• Single +5V Power Supply
• Uses Minimum External components
• Operates over -40°C to +85°C Temperature Range
• Available in an 80 pin TQFP package
XRT7302 BLOCK DIAGRAM
E3_Ch(n) STS-1/DS3_Ch(n) Host/HW
RLOL(n) ExClk(n)
RxClkINV
RTIP(n)
RRing(n)
REQEN(n)
RxOFF(n)
LOSTHR(n)
SDI
SDO
SClk
CS
REGR
TTIP(n)
TRing(n)
MTIP(n)
MRing(n)
DMO(n)
AGC/
Equalizer
Slicer
Clock
Recovery
Peak Detector
LOS Detector
Data
Recovery
Serial
Processor
Interface
Loop MUX
Invert
HDB3/
B3ZS
Decoder
Device
Monitor
Pulse
Shaping
HDB3/
B3ZS
Encoder
Transmit
Logic
Duty Cycle Adjust
Channel 1
RxClk(n)
RPOS(n)
RNEG(n)
LCV(n)
ENDECDIS
RLOS(n)
LLB(n)
RLB(n)
TAOS(n)
TPData(n)
TNData(n)
TxClk(n)
TxLEV(n)
TxOFF(n)
Channel 2
Notes: 1. (n) = 1 or 2 for the respective channel.
2. Serial Processor Interface pins are shared by both Channels in "Host" mode and are redefined in "Hardware" Mode.
Exar Corporation 48720 Kato Road, Fremont CA, 94538 • (510) 668-7000 • FAX (510) 668-7017 • www.exar.com