DM9010 View Datasheet(PDF) - Davicom Semiconductor, Inc.
Part Name
Description
MFG CO.
DM9010
Davicom Semiconductor, Inc.
'DM9010' PDF : 61 Pages View PDF
DM9010
Single Chip Ethernet Controller with General Processor Interface
7. EEPROM Format
name
Word
MAC address
0
Auto Load Control
3
Vendor ID
4
Product ID
5
pin control
6
offset
0~5
6-7
8-9
10-11
12-13
Description
6 Byte Ethernet Address
Bit 1:0=01: Update vendor ID and product ID
Bit 3:2=01: Accept setting of WORD6 [8:0]
Bit 5:4=01: Accept setting of WORD6 [11:9]
Bit 7:6=01: Accept setting of WORD7 [3:0]
Bit 11:10=01: Accept setting of WORD7 [7]
Bit 13:12=01: Accept setting of WORD7 [8]
Bit 15:14=01: Accept setting of WORD7 [14]
2 byte vendor ID (Default: 0A46H)
2 byte product ID (Default: 9000H)
When word 3 bit [3:2]=01, these bits can control the IOR#, IOW# and INT pins
polarity.
Bit0: Reserved
Bit1: IOR# pin is active low when set (default: active low)
Bit2: IOW# pin is active low when set (default: active low)
Bit3: INT pin is active low when set (default: active high)
Bit4: INT pin s open-collected (default: force output)
Bit 8:5: Reserved
Wake-up mode control 7
RESERVED
8
RESERVED
9
RESERVED
10
RESERVED
11
14-15
16-17
18-19
20-21
22-23
When word 3 bit [5:4]=01, the I/O base can be re-configured.
Bit11:09: I/O base (default: 300H)
000 : 300H
001 : 310H
010 : 320H
011 : 330H
100 : 340H
101 : 350H
110 : 360H
111 : 370H
Bit15:12: reserved
Bit0: The WAKE pin is active low when set (default: active high)
Bit1: The WAKE pin is in pulse mode when set (default: level mode)
Bit2: magic wakeup event is enabled when set. (default: disable))
Bit3: link_change wakeup event is enabled when set (default: disable)
Bit6:4: reserved
Bit7: LED mode 1 (default: 0)
Bit8: internal PHY is enabled after power-on (default: disable)
Bit13:9: reserved
Bit14: 1: HP Auto-MDIX ON, 0: HP Auto-MDIX OFF(default ON)
Bit15: reserved
Preliminary
30
Version: DM9010-17--DS-P04
Jan. 18, 2006
Share Link: 